I would like to use the CRANEWAY add-on module to design a suspension crane. Where are design points 0, 1, and 2 for the stress analysis on the bottom flange and for the fatigue design?
For a calculation, I activated the "Detailed Calculation" option. Have the support loads already been specified with the reduced dynamic coefficient for the design of the substructure?
If I rotate my model in view, the model center is always the rotation center point. Can I also put the rotation center in the center point of the current view?
A crane runway has small cantilevered girders at the start and end, so that the wheels go as far as the column. In these areas, the deformations show invalid values. What should I do?